Model so 3-2-1 Voltage 220 volts Output 3 inches Maximum height 30 cm Maximum discharge 700-120 the power 2.2 kW Maximum amp 16 far 2800 rpm Weight 36 kg Description of Spico three-inch floating pump Features of Spico three-inch floating pump: Spico three-inch floating pumps with stainless steel impellers and silicon carbide seals are designed and manufactured for water transfer from shallow wells and for agricultural, industrial and domestic purposes, as well as for waterproofing. The SPico floating pumps of the SO3 model with a 3-inch outlet are designed for single-phase pumps and voltage (10% ± 380) for three-phase pumps due to mains voltage fluctuations (10% ± 220). When the pump is switched on and off, deadly blows, so-called ram blows, are applied to the pump and the pipe connected to it. After a while, the pipe may be detached from the pump, so the spico has 2 brass screws on both sides of the outlet. It is designed to prevent the pipe from leaking from the pump as it hardens. All SPICO diffusers are equipped with a rubber crown that is designed to prevent corrosion of the impeller and diffuser, and if you use water containing abrasives and excessive corrosion, replacing this rubber crown will save you a lot of money. The body and main components of the floating pump are made of ductile iron, which is highly resistant to impact and corrosion. All spilled parts are alloyed by specialists so that there is no Mc and Suse in the parts, however, Spico leaks all its sensitive cast parts by special resin, thus the percentage of water penetration into the electric motor. To reach zero All floating pumps use good quality anti-wear mechanical seals (silicon carbide) to increase the life of the pump. Use butterflies, shafts and stainless steel screws that are highly resistant to rust and corrosion. In designing SPico floating pumps for better and more reliable quality and increasing the life of mechanical seals, a chamber filled with special oil between the pump and the electric motor is considered, which is completely sealed by two special mechanical seals and 2 oil seal bowls. Water permeability to the pump is reduced to zero, and it is possible to see the oil inside it by screwing Allen score 8 on the side and bottom of the pump. (It should be noted that the oil used is edible paraffin to prevent environmental pollution and is in accordance with ISO-14001 standard.) All single-phase pumps equipped with Thermo Guard system are designed and manufactured to protect the winding. All SPICO pumps have a specific serial number, which is the pump identification number engraved on the body. tip: At the end of the floating pumps, there is a special compression tire that, if the electronic control panels are not used accurately, burns the dynamo for any reason and does not cut off the power fuse, and after burning, the power supply is established. It directs the electromotor and eventually, when torn, transmits the internal pressure to the outside, which prevents the dynamo from exploding.  The price of a semi-deep well pump is the price of a floating pump. The price of a three-inch floating pump.                              Write a comment